Strokes and Shots

How to Smash Harder in Badminton Without Just Swinging Harder

Smash harder in badminton by building power through the body, not arm effort: the kinetic chain, a clean contact at the peak, a relaxed grip and timed footwork.

On this page
  1. Quick answer
  2. Where smash power really comes from
  3. Legs and hips
  4. Torso, the lag and the whip
  5. Contact: high, in front, and clean
  6. The grip: loose until contact, then squeeze
  7. Footwork and the jump
  8. Racket and string choices, briefly
  9. What does not add power
  10. Strength work that helps
  11. Safety for the shoulder
  12. Drills

Quick answer

To smash harder, build power through the body rather than the arm. Start with the legs and hips, let the torso rotate, and let the arm follow with a whip-like action. Contact the shuttle high and in front of your body, at its highest point, with a clean, flat strike. Keep the grip loose until contact, then squeeze. A bigger arm swing usually makes the smash slower, because it adds tension.

Where smash power really comes from

Smash power comes from a sequence of movements, each one passing energy to the next. The order runs from the legs and hips, through the trunk and shoulder, to the elbow, forearm and fingers. The biggest contributors to racket head speed are the internal rotation of the shoulder and the pronation of the forearm, not the wrist alone. Arm effort is only one part of the chain.

Legs and hips

Power starts from the floor. Push off with the racket-side leg, and drive the hip forward to start the rotation. Stay side-on to the net with your weight on the back foot, so there is space to turn into the shot.

Torso, the lag and the whip

As the hips turn, the torso follows. Keep the elbow back for a moment while the torso turns. This stretches the chest and shoulder, and the arm then whips forward with more speed. The effect is often called a lag: the racket trails the body, then catches up.

Do not rush the arm. An arm that starts early loses the lag, and the smash becomes a push.

Contact: high, in front, and clean

Contact the shuttle near the top of its flight, high and in front of your body. A contact behind the head loses both power and steepness. Hit the shuttle with the sweet spot of the strings, in a direct, flat strike. Avoid slicing or undercutting the shuttle, because that absorbs speed.

For the shot-by-shot contact points, see contact point in badminton.

The grip: loose until contact, then squeeze

Keep the grip relaxed during the backswing and the acceleration. A tight grip stiffens the forearm and slows the racket head. At the moment of contact, squeeze the fingers firmly, so the racket head is stable and gains speed. The squeeze is quick and then you relax again.

For the grip itself, see what grip to smash in badminton.

Footwork and the jump

Get behind the shuttle early. A smash taken from a good position uses the whole chain. If you are off balance, the body cannot rotate fully, and the smash loses power.

A scissor jump adds height and rotation, which can make the smash steeper. Time the jump so you strike at the top of the shuttle’s flight, not while you are already falling. For the full technique, see the jump smash guide.

Racket and string choices, briefly

Equipment matters less than technique, but it is worth knowing two points:

  • String tension. Very high tension usually reduces power for most players (see what tension to string your racket), because the strings feel firmer and give less. It also gives more control, so the right tension is a trade-off.
  • Racket weight and balance. A heavier racket does not automatically smash faster. A racket that suits your swing speed is the one to choose. See racket weight and head-heavy vs head-light rackets for the trade-offs.

If you are unsure about tension or weight, ask a stringer or a coach for advice before you change anything.

What does not add power

  • More arm effort. Swinging harder with the arm tenses the muscles and slows the racket.
  • A tighter grip. Holding the racket tightly all through the swing stiffens the wrist and forearm.
  • Wrist flicking on its own. The wrist is part of the chain, but it is not the main source of power.
  • Heavier racket for its own sake. Weight alone does not make a smash faster.

Strength work that helps

Strength for the legs, the core and the shoulder rotators supports smash speed. Leg strength drives the first part of the chain, core strength transfers the rotation, and the rotator muscles stabilise the shoulder. Build these gradually, and include exercises for the rotator cuff.

Safety for the shoulder

Repeated full-power smashes put strain on the shoulder and elbow. Limit the volume of full-power smash drills, and warm up before you start. If you feel pain in the shoulder or elbow that does not settle, reduce the load and get advice. How to prevent badminton elbow covers the elbow side.

Drills

  • Shadow the chain. Practise the hip, torso and arm sequence without a shuttle, slowly, then at speed.
  • Feed for contact. A partner feeds high shuttles, and you check that you meet each one at the top and in front.
  • Grip and squeeze. Practise a relaxed backswing and a firm squeeze at contact, with no shuttle first.

The complete guide to strokes and shots

Badminton Techniques: Every Shot and Skill Explained
Read the guide

Keep exploring

Guides from other topics

All topics →