Quick answer
A jump smash is a smash hit at the top of a jump. The jump lets you contact the shuttle higher, which gives a steeper angle and more power. It costs more energy and recovery time than a standing smash, so use it when the shuttle reaches you early and your opponent is under pressure. Keep the arm action the same as a standing smash, and land balanced with soft knees.
What a jump smash gives you
Jumping adds height, which means you can meet the shuttle higher and hit it more steeply. A steeper smash is harder to return, especially when it is aimed at the sidelines or the body. The jump also lets you disguise the shot until the last moment, because the racket is hidden above your head.
Jumping higher does not guarantee more power. Timing and arm speed matter more than the height of the jump.
Get behind the shuttle first
The jump only works if you are in the right place. Move early, as soon as the opponent lifts or clears, so the shuttle is in front of you at the point of contact. A jump taken too late, or without getting behind the shuttle, usually means late contact and a weak smash.
Load your legs with a low, balanced stance: feet about shoulder-width apart, knees bent, and weight over the balls of your feet.
Two jumps: the two-foot jump and the scissor kick
There are two common ways to take off:
- The two-foot jump. You take off from both feet and land on both feet. It is common in doubles, in the middle of the court.
- The scissor kick. Your legs switch in the air (compared with the China jump in badminton footwork). Land on the non-racket foot first, then step forward onto the racket leg to recover.
Which one suits you depends on the shot and where you are on the court. Coaches differ on the exact landing sequence in a scissor kick, so check with a coach if you are unsure.
Preparation in the air
Start with the same grip you use for a standing smash, a forehand grip with the fingers holding the racket. Pull the racket arm back with the elbow bent at about 90 degrees, and point the non-racket arm up towards the shuttle. The non-racket arm helps you balance and aim.
As you rise, open the chest and let the body arch a little. Then rotate the hips and torso forward, and bring the shoulder and elbow through in a whip-like motion. Keep the grip loose until the moment of contact.
Contact at the peak
Make contact near the peak of the jump, high and in front of your body. Contact behind the shoulder costs power and steepness. Use forearm rotation and a firm squeeze of the fingers at impact, then keep the follow-through short and aimed down towards the sidelines, the body or the middle of the court.
Timing decides the shot. Jump too early and you lose the angle; jump too late and you lose both power and steepness. Practise the timing with a partner feeding high shuttles.
Landing and recovery
Land with your knees bent and your weight balanced over your feet. A soft, controlled landing lets you move straight into the next shot. Push off quickly towards the centre of the court, because the opponent’s reply often comes straight back.
Beginners often smash well but land badly, which delays their recovery. Work on the landing as much as the smash itself.
When to jump and when to stand
Use a jump smash when:
- The shuttle is reachable early, so you can get behind it.
- Your opponent is out of position or under pressure.
- A standing smash would be too low or too flat to be effective.
Smash from a standing position when the shuttle is already low, when you are stretched, or when you are not sure you can recover after a jump. Save the jump smash as a surprise shot. Overusing it makes it predictable and tiring.
Common mistakes
- Jumping for height alone. The aim is a steeper, controlled smash, not a bigger jump.
- Jumping without getting behind the shuttle. This usually causes late contact.
- Power without control. A hard smash that goes out or into the net helps the opponent more than it helps you.
- Landing on stiff legs. This increases the strain on your knees and tendons.
Knee and tendon safety
Landing with stiff knees, or with the knee collapsing inwards, puts stress on the knee and can injure the ligaments. See is badminton risky for the injuries players see most. Repeated jumping loads the patellar tendon, which sits just below the kneecap. Build the number of jump smashes gradually, and include leg and calf strength in your training. For more on this, see what exercises to do for badminton. Stop and seek advice if you have knee or tendon pain that does not settle.
Drills
- High feeds. A partner feeds high shuttles, and you practise getting behind them and jumping to the peak.
- Jump without a shuttle. Practise the take-off, the arm action and the landing with no shuttle.
- Jump smash to a target. Aim smashes at a marked spot on the court, and note where the landing leaves you.
For the standing smash that the jump builds on, see the badminton smash guide. For the grip, see what grip to smash in badminton.