The serve starts every rally, so it is worth getting right. There are two families of serve. Short serves travel low over the net and land near the front of the opponent’s court. Long serves go high and deep toward the back. Both have to be legal before they count, so the rules are the place to start.
Serve rules at a glance
Under the BWF Laws of Badminton, a legal serve has to meet these conditions:
- The server and receiver stand in diagonally opposite service courts, without touching any boundary line.
- Both players keep some part of both feet on the floor, stationary, until the server hits the shuttle.
- Once the racket starts forward, it keeps moving forward in one continuous motion until it hits the shuttle.
- The server strikes the base (cork) of the shuttle first.
- The whole shuttle is below 1.15 m from the court surface at the moment it is hit, and it travels upward off the racket.
- The shuttle lands in the diagonally opposite service court. Lines count as in.
Each rule has its own fault, which is covered in illegal serves and service faults.
Service courts and which side to serve from
Singles and doubles use different service courts, as laid out in badminton court dimensions. In singles, the court runs between the inner sidelines and reaches the back boundary line. In doubles, it runs between the outer sidelines and stops at the doubles long service line, which is 0.76 m in front of the back boundary line. The short service line is 1.98 m from the net in both formats.
Choose the side by score. Serve from the right service court when your score is even (0, 2, 4 and so on), and from the left when it is odd.
The 1.15 m height rule
Under the current BWF laws, the limit is a fixed height. The whole shuttle must be below 1.15 m at the moment of contact. At elite events, a service judge checks this with a measuring device.
You may still come across the older rule, which requires the shuttle to be struck below the waist, with the racket shaft pointing down. Some club and national levels still use it. Check the rules of the event or club before you play.
Feet, contact and motion
Keep both feet planted until the shuttle is hit. Lifting, dragging or moving a foot is a fault, and so is touching a line. A short backswing before the forward movement is normal. Once the forward movement starts, pausing, faking or rocking the racket back and forth is not allowed.
Grip, stance and holding the shuttle
For most short serves, use a relaxed backhand grip, held high on the handle, with the thumb resting on the wide back of the handle. Long serves are usually hit with a forehand grip.
For a right-handed player, the common short-serve stance is the right foot forward, with the toes pointing toward the net and the feet about shoulder-width apart. Stances vary, so pick the one that keeps your weight balanced and lets you move.
Hold the shuttle by the feathers, not the cork. The cork base should face the racket, so that the cork is what the racket meets first. Hold the shuttle in front of your body, well below 1.15 m.
The short serve (low serve)
The short serve is the default in doubles and is widely used in singles. It is a gentle push rather than a swing. The shuttle should peak on your side of the net, clear the tape by a few centimetres, and drop just past the short service line.
Push with the forearm and thumb, and use little or no wrist snap. A wrist flick makes the height inconsistent. Common targets include the T (where the centre line meets the short service line), the wide corner by the sideline, and the receiver’s body or racket hip.
For a step-by-step walkthrough, see how to do a backhand serve in badminton.
The long serve (high serve)
The long serve sends the shuttle high and deep toward the back boundary line. It is a traditional singles serve. It is usually hit with a forehand, underarm action, and the shuttle must still stay below 1.15 m and travel upward.
Height, not power, gives a good long serve. Hitting harder usually makes the shuttle go long. A good high serve drops almost vertically near the back line.
Flick and drive serves
Once the short serve is reliable, two surprise serves are worth learning. A flick starts with the same setup as a short serve, then the wrist and fingers snap at the last moment to send the shuttle fast toward the back of the court, just over the receiver’s reach. A drive is flat and fast, aimed at the receiver’s body or backhand shoulder.
Both are mainly doubles tools, and both must still be legal. The full technique is in flick and drive serves.
Can the receiver smash a serve?
Yes, once the serve is legal. The server cannot smash the serve itself, because a legal serve is hit below 1.15 m and travels upward. The full answer is in is smash allowed after service in badminton.
Common serving faults
Most serving problems fall into three groups: the serve goes too high or too long, it lands short or hits the tape, or it goes wide. See why your badminton serve keeps going out for the likely causes and a drill to fix them.
Where to go next
- Serve return: where the receiver stands and how to respond.
- Serving strategy: how to choose serves in a match.
- Illegal serves and service faults: the full list of faults.