A serve that keeps going out usually goes out in one of three ways: it goes long, it lands short or hits the tape, or it goes wide. Start with where the shuttle lands, because that tells you which cause to check first. The badminton serve technique overview covers the correct targets for each serve.
Serve goes long
A long serve lands beyond the back boundary line in singles, or beyond the doubles long service line in doubles. Two causes come up most often.
Over-swinging with a wrist snap
A high serve should come from a smooth arm lift. If you swing too hard or snap the wrist, the shuttle climbs higher and flies further than you meant. Hitting harder doesn’t solve this. A good high serve gets its depth from height, not power, and drops steeply near the back line.
Flick aimed at the back boundary line in doubles
In doubles, a flick should land near the doubles long service line, which is 0.76 m in front of the back boundary line. Players often aim at the back line itself. That leaves no margin for error, so flicks tend to go long. Aim for the doubles long service line instead, and leave a little margin.
Serve lands short or hits the tape
A short serve that goes out usually lands before the short service line. The cause is either a push that is too soft, or one that is too flat and clips the tape. A good short serve peaks on your side of the net, clears the tape by a few centimetres and drops just past the short service line. The backhand serve is the usual short serve in doubles, so its push is a good place to start.
If the serve touches the net but still lands in the correct service court, it is good and play continues. If it lands outside the correct court, it is a fault. A serve that clips the tape isn’t automatically wrong, so check whether it fell short or landed outside before you change anything.
The usual fix is in the push. Use your forearm and thumb to lift the shuttle up and over the tape, and keep the wrist still. A wrist flick makes the height inconsistent. Too little push leaves the shuttle short, and a flat push hits the tape.
Serve goes wide
A wide serve lands outside the sideline of the court you are aiming for. Two faults usually cause it:
- The racket face is angled when you hit the shuttle, so the shuttle leaves at an angle.
- Your body faces the wrong way, so your shoulders and feet point away from the target.
Before you serve, line your shoulders and feet up with the target. Keep the racket face square to that target at contact. Then check the next few serves to see whether the shuttle keeps drifting the same way.
Contact point and consistency
The point where the racket meets the shuttle decides how high and how far it goes. Contact too far in front of you, or too low, makes the shuttle rise higher and travel further. Pick a contact point you can repeat, and keep it the same on every serve. Consistency comes from a repeatable contact point, not from a bigger swing.
Check the shuttle and conditions
Sometimes the technique is fine and the shuttle is the problem. Feather shuttles come in different speeds, and the right speed depends on the hall’s altitude and temperature. A shuttle that is too fast for the hall can fly long on every serve, however good your technique is. Plastic shuttles also fly differently from feathers, and speed grades vary by brand.
If every serve goes long in one hall but not in another, check the shuttle before you change your swing.
A drill to fix it
Place a towel or a cone just inside the line you are aiming for. For a short serve, that is just past the short service line. For a long serve, put the target just inside the back boundary line in singles, or just inside the doubles long service line in doubles.
Serve 20 to 30 shuttles at the target. Keep the swing shape the same, and change only how hard you hit. Count how many land on the target. A simple goal is to land at least 15 out of 20 before you change anything else in your technique.
Common myths
- “Hit harder for a better high serve.” Height, not power, gives depth and a steep drop.
- “Doubles and singles serves land in the same place.” They don’t. A high serve that lands on the back boundary line is in singles, but it is out in doubles, because the doubles service court stops at the long service line.
- “A serve on the line is out.” Lines are in. A serve that lands on a line of the correct court is good.
- “It’s always technique.” Shuttle speed and hall conditions can push every serve long.
If a serve is being called a fault and you are not sure why, check badminton illegal serves and service faults.