Serving

Badminton Flick Serve and Drive Serve

Learn how to hit a badminton flick serve and drive serve: the disguise, the late wrist snap, where to aim in doubles, and the rules both serves must follow.

On this page
  1. Quick comparison
  2. What is a flick in badminton?
  3. How to hit a drive serve
  4. Doubles or singles?
  5. Are flick and drive serves legal?
  6. Common mistakes
  7. When to use them

The flick serve and the drive serve are both surprise serves built on the short serve. Each starts with the same setup as a short serve, so the receiver has less time to read it. Both are mainly used in doubles, and both must follow the same service rules as any other serve.

Quick comparison

Flick serve Drive serve
Path Fast and low, just over the receiver’s reach, toward the back of the court Flat and fast, toward the receiver’s body or backhand shoulder
Main purpose Push the receiver back Catch the receiver leaning forward
Where it is used Doubles and singles Mainly doubles
Key cue Late wrist and forearm snap Short swing and a squeeze of the grip at contact

What is a flick in badminton?

A flick serve is a deceptive serve. The server starts in the same stance, grip and racket position as a short serve, then accelerates late and sends the shuttle deep. Its value is the disguise. The receiver expects a short serve and moves in, so the shuttle goes past them.

Setup: the same as the short serve

Use the same grip, stance and backswing as your short serve. Keep your feet still, and do not lean back or change your setup early. Once the receiver reads the serve, the flick loses its effect.

The snap at contact

Flick power comes from a short, late acceleration rather than a big swing. Keep the racket moving forward, rotate the forearm, and snap the wrist at the last moment. Squeeze the thumb and fingers on the grip just before contact, then follow through briefly.

Height and target

Aim for a height that is just high enough to pass over the receiver’s raised racket. A flick that is too high gives the receiver time to smash.

In doubles, aim just inside the doubles long service line, which sits 0.76 m in front of the back boundary line. Most flicks go to the receiver’s backhand corner or the centre. Aiming at the back boundary line is a common error, and it often sends the flick out.

How to hit a drive serve

A drive serve is flat and fast. It travels on a low, quick path toward the receiver’s body or backhand shoulder. It works best against a receiver who is leaning forward for a short serve.

Grip and short swing

Set up the same way as your short serve, then keep the swing short. A large, looping swing gives the serve away. Drive serves are more often played with a forehand grip, although backhand drives are also possible.

Contact and trajectory

Generate speed at contact by squeezing the grip with the thumb and fingers, combined with a quick wrist or forearm action. The shuttle still has to pass the net and travel upward off the racket, and it must stay below 1.15 m when it is hit. A truly flat drive is harder to keep legal for taller players, because the 1.15 m limit sits lower on their body.

Where to aim (and safety)

Many players do not cover the backhand well in their ready stance, so the backhand side is a common target. An across-the-body drive can also catch the receiver out. Aim at the chest or shoulder, not the head. A drive aimed at the body can reach the face at close range, so keep your target low on the body.

Doubles or singles?

Both serves are mainly doubles weapons. In doubles, the receiver usually stands close to the short service line, so a flick sent to the back of the court can catch them out. In singles, a flick works well against an opponent who stands close. Land it near the back boundary line.

Yes, as long as they meet the normal service rules. The whole shuttle must be below 1.15 m at contact, the cork must be hit first, the shuttle must travel upward off the racket, both feet must stay still, and the racket must move forward in one continuous motion. Serves that add spin before contact are a different case and are not allowed under current BWF rules.

For the full list of faults, see illegal serves and service faults.

Common mistakes

  • Treating the flick as a high serve. It should be fast and low, just over the receiver’s reach.
  • Making a big swing for a flick. The power comes from a short, late snap.
  • Using the flick too often. Once the receiver reads it, it is easy to smash.
  • Telegraphing the serve by leaning back or changing your setup.
  • Aiming a drive at the head.

When to use them

Both serves work best as occasional changes rather than a pattern. The flick is most useful when the receiver crowds the short service line or leans forward. If the receiver reads a flick early, expect a smash, so move back to defence straight away.

For how to choose serves during a match, see serving strategy. For what the receiver does, see how to return a serve. For the basics, see the serve technique overview.

The complete guide to serving

Badminton Serve Technique: Short and Long Serves
Read the guide

Keep exploring

Guides from other topics

All topics →

How to Play Badminton Doubles

A beginner's guide to badminton doubles: the court, serving and scoring, attack and defence formations, rotation, calls and the next steps for each skill.

Doubles 6 min read